Using the outlet is a very simple affair. The surge protector will help ensure that your connections stay tight and that there is no damage done by any unexpected power spikes.Įnsure to check the rating of the surge protector you buy and make sure it’s rated for 50 amps so that it can handle the load of your RV plug. It’s also a good idea to use a surge protector for your RV outlet to protect your electronics from power surges. This device will ensure that everything is connected correctly and working properly before you start your trip. It’s easy to use and can help you test for continuity, voltage, current, resistance, and more. This is a great tool for testing your RV outlet. AstroAI Multimeter 2000 Counts Digital Multimeter If not, then you may need to adjust one of your connections until there is good contact. The device should show zero ohms if there is good contact between the plugs and wires. If you don’t have a voltage tester handy, then use an Ohm meter or multimeter to test for continuity. Make sure to use a voltage tester to check the wiring one last time before you hit the road. Ensure that your connections are tight and that they won’t come loose while you drive. Testing the outlet once everything is connected is a must. For more tips on wiring and other electrical projects, be sure to check out our blog for advice from professional electricians. You can easily wire an RV plug, allowing your recreational vehicle to take advantage of the power provided by a standard electric outlet. Once it is working properly, be sure to affix any covers over exposed wiring so as not to risk electric shock or fire hazard when not in use. With all three wires connected, turn on the main breaker and test your connection by plugging in an appliance or device that requires 50 A of electricity.Secure all of these connections using screws and a screwdriver or nut driver. Once you have your hot wire secure in place, attach the white neutral wire from your RV power cord to the terminal marked “N”.If you are using a non-metallic sheathed cable, you will also need to attach the bare ground wire to the terminal marked “GND”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |